Pelco IS310-DW, IS310-CW, IS310-CH manual Important Safety Instructions

Page 2

Important Safety Instructions

1.Read these instructions.

2.Keep these instructions.

3.Heed all warnings.

4.Follow all instructions.

5.Do not block any ventilation openings. Install in accordance with the manufacturer’s instructions.

6.Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat.

7.Only use attachments/accessories specified by the manufacturer.

8.Use only with the cart, stand, tripod, bracket, or table specified by the manufacturer, or sold with the apparatus. When a cart is used, use caution when moving the cart/apparatus combination to avoid injury from tip-over.

9.Refer all servicing to qualified service personnel. Servicing is required when the apparatus has been damaged in any way, such as power-supply cord or plug is damaged, liquid has been spilled or objects have fallen into the apparatus, the apparatus has been exposed to rain or moisture, does not operate normally, or has been dropped.

10.Installation should be done only by qualified personnel and conform to all local codes.

11.Unless the unit is specifically marked as a NEMA Type 3, 3R, 3S, 4, 4X, 6, or 6P enclosure, it is designed for indoor use only and it must not be installed where exposed to rain and moisture.

12.Use only installation methods and materials capable of supporting four times the maximum specified load.

13.Use stainless steel hardware to fasten the mount to outdoor surfaces.

14.To prevent damage from water leakage when installing a mount outdoors on a roof or wall, apply sealant around the bolt holes between the mount and mounting surface.

15.CAUTION: These servicing instructions are for use by qualified service personnel only. To reduce the risk of electric shock do not perform any servicing other that contained in the operating instructions unless you are qualified to do so.

16.Only use replacement parts recommended by Pelco. The product and/or manual may bear the following marks:

This symbol indicates that dangerous voltage constituting a risk of electric shock is present within this unit.

This symbol indicates that there are important operating and maintenance instructions in the literature accompanying this unit.

CAUTION:

RISK OF ELECTRIC SHOCK.

DO NOT OPEN.

2

C3429M-A (1/08)

Image 2
Contents IS310 Series Camclosure Important Safety Instructions Regulatory Notices Parts List DescriptionInstallation Prepare Wall or CeilingConnect Video and Power Mounting to a 2-gang electrical boxAttach Base Exploded Parts ViewAdjust Enclosure Adjusting Enclosure PositionSW4-2 Backlight Compensation DN/CH Series AdjustmentsSW4-1 Auto Gain Control SW4-3 Line SyncSW4-5 Auto White Balance/Manual White Balance SW4-6 ReservedBlemish Detection DAY/NIGHT Operation SW1-2 Line Sync DW/CW Series Wide Dynamic Range AdjustmentsSW1-1 Video Format SW1-3 Interlaced Scanning/Progressive ScanningSW1-6 General Maximum Wide Dynamic Range SW1-4 Auto White Balance/Manual White BalanceSW1-5 Fluorescent/General SW1-7 Digital Slow ShutterDark on Dusk OFF Color to B-W Auto Iris Level Adjustment Service Connector Attaching the 2.5 mm Monaural Headphone PlugSpecifications GeneralProduct Warranty and Return Information ISO9001