Pelco IS310-CW, IS310-CH, IS310-DW Connect Video and Power, Mounting to a 2-gang electrical box

•Mounting to a 2-gang electrical box

WALL OR CEILING

ICS310-AP ADAPTER PLATE (NOT SUPPLIED)

2-GANG ELECTRICAL BOX

6-32 X 0.50 SECURITY SCREW (SUPPLIED WITH ADAPTER PLATE)

Figure 4. Mounting to a 2-Gang Electrical Box

CONNECT VIDEO AND POWER

1.Some indoor installations do not require a heater. If the installation does not require a heater, disconnect the heater wiring.

a.Remove the cover with the supplied 1/8-inch hollow screwdriver bit.

b.Remove the camera from the mounting bracket, and unplug the 4-pin heater connector in the base.

c.Reinstall the camera. If the camera has a varifocal lens, leave the cover off; it will be reinstalled later. Otherwise, reinstall the cover.

2.Connect the power input wires to the power wires of the IS310 base (refer to Table A).

Table A. Power Input

Voltage	Red Wire	Black Wire
12 VDC	+	Ground
24 VAC	~	~

3.Connect the video cable/wires:

•BNC: Connect the BNC connector from the unit to a mating BNC connector.

•UTP: Connect the blue wire to Video +; connect the gray wire to Video -.

6 C3429M-A (1/08)