ADJUST ENCLOSURE
1.Turn on power to the camera and monitor.
2.Release one or both locking rings, and swivel the enclosure until the angle of the camera is correct (refer to Figure 7).
3.Tighten the locking rings.
LOCKING RINGS
Figure 7. Adjusting Enclosure Position
4. If you have a varifocal lens, remove the cover with the supplied
WARNING: Heater elements could be hot! When camera power is on, use caution when adjusting the camera. This applies to all models.
5.Loosen the focal length and focus locking screws (refer to Figure 8), and then adjust the lens according to the scene detail.
VARIFOCAL LENS
LOCKING
SCREWS
Figure 8. Varifocal Locking Screws
6.Retighten the screws.
7.Reseat the O-ring on the cover and reinstall the cover.
8 |