Pelco IXE manual Imaging TAB, Orientation

IMAGING TAB

Use the Imaging tab to change the camera orientation or to adjust digital processing, exposure, focus, tone map, and white balance.

GENERAL

The general imaging settings allow you to change the camera’s orientation and adjust digital processing.

Figure 21. Orientation and Digital Processing Page

Orientation

The camera can be installed in a standard or inverted position. When installed for inverted operation, the camera orientation needs to be reconfigured for normal operation. If the image is not reconfigured, the picture will be upside down and mirrored. The available settings for camera orientation are as follows:

Flip left-to-right:Creates a mirror image by rotating the camera image 180 degrees horizontally.

Flip top-to-bottom:Rotates the camera image 180 degrees vertically.

To reconfigure the camera for an inverted installation:

1.Click the Imaging tab, and then select General from the drop-down menu.

2.Select the "Flip left-to-right" selection box.

3.Select the "Flip top-to-bottom" selection box.

28 C2953M-A (5/09)