Reset Button
Use the reset button located underneath the trim ring on the mounting flange to access the following modes:
Mode | Function | Unit Status Indicator Light |
|
|
|
Configuration | Starts the reset LED | Flashes green. |
| selection sequence. |
|
|
|
|
Reboot | Restarts the unit. | Flashes green and red simultaneously when entering this |
|
| mode. The LED then flashes green when mode is selected |
|
| and during the reboot. |
|
|
|
Reset | Resets unit to factory | Flashes red when entering this mode. Flashes red when |
| default settings and | mode is selected, and then flashes green when dome |
| then restarts unit. | system restarts. Dome system is off line during reset |
|
| mode. |
|
|
|
Cancel | Cancels any | No light. |
| configuration or reset |
|
| action. |
|
|
|
|
To access one of these modes:
1.Press and hold the reset button. The unit starts cycling through the modes; hold the button for four seconds to access (cycle through) each mode. The unit status indicator LED flashes the color for the current mode (refer to the table above).
2.When the color of the desired mode appears, release the button.
NOTES:
•If there is no configuration activity for 15 minutes, the dome system will automatically exit the reset mode.
•The LED is not lit during normal operation.
Figure 19. Location of Reset Button and LED
Status Indicator LED
Reset Button
22 | C3446M (7/08) |