Pelco BB5L operation manual Specifications, Mechanical, Electrical, General

Page 17

 

6.0 SPECIFICATIONS

 

 

 

 

MECHANICAL

 

Construction

 

Back box:

Aluminum

Cable Entry

 

In-Ceiling:

.75" (1.91 cm) conduit fitting

Pendant:

Through 1.5" (3.81 cm) NPT pendant mount

Dimensions:

See Figure 12

ELECTRICAL

 

Input Voltage:

18-30 VAC, 24 VAC nominal

Input Power

In-ceiling: 25 vA

Indoor pendant: 25 vA

Outdoor pendant: 90 vA

Fuse:

1.6 A

Relay

 

Contacts (AUX 1)*

 

Type:

Form C

Voltage:

Low voltage (< 40 v)

Current:

2 A maximum

AUX 2 Output*

 

Type:

Open collector transistor output

Voltage:

32 VDC maximum

Current:

150 mA maximum

* Applies to Spectra™ (Version 3.0) and Spectra II™ only.

GENERAL

Environment

In-Ceiling: Indoor only

Pendant: Indoor/outdoor

Operating Range

In-Ceiling: 32° to 122°F (0° to 50°C)

Pendant

Without heater: 32° to 122°F (0° to 50°C)

With Heater*: -60°to 122°F (-51.11°to 50°C) continuous operation; minimal icing -50°to 122°F (-45.56°to 50°C) continuous operation; prevents icing

-40°to 122°F (-40°to 50°C) continuous operation; de-ices 0.1" (2.5 mm) within 3 hours after power-up

Weight

Unit

Shipping

In-Ceiling

 

 

Back Box

2.6 lbs (1.18 kg)

4.0 lbs (1.81 kg)

Pendant

 

 

Back Box

2.85 lbs (1.28 kg)

5.0 lbs (2.27 kg)

*Assumes no wind chill factor; for detailed test conditions, contact Pelco.

Add 1.25 lbs (.57 kg) for outdoor models with sun shield and heater

(Design and product specifications subject to change without notice.)

Pelco Manual C1488M-A (9/98)

17

Image 17
Contents Listed Contents General Important Safeguards and WarningsRegulatory Notices Recommended Tools Unpacking InstructionsIN-CEILING Models Pendant ModelsModels DescriptionCertifications FCCCeiling and Back BOX Preparation Installation for IN-CEILING ModelsProceed to .2, Wiring Proceed to .3, Back BOX Installation WiringMaximum Distance RG6/UHard Ceiling Ceiling Tile Wiring Diagram for Spectra Ver .0 and Spectra Wire Gauge Proceed to .4, Back BOX Connections Back BOX InstallationBack BOX Connections Dome 1 Power Dome 2 Power Dome 3 PowerRX+ TX+ From controller To 4-Wire terminal on circuit boardSURFACE-MOUNT Installation Installation for Pendant ModelsPENDANT-MOUNT Installation Symptom LED does not light TroubleshootingMechanical SpecificationsElectrical GeneralSD5 Series Dimension Drawing Pelco Manual C1488M-A 9/98 Returns Warranty and Return InformationWarranty