Lens
1
2 |
bts1009
4 | 3 |
5 |
To attach a lens to the camera head proceed as follows:
a. Ensure that the lens locking ring 1 is in the unlocked position - turned counterclockwise.
b.Remove the dust protection cap 2 .
c.Slot the lens into the lens mount 3 .
d.Turn the lens locking ring 1 clockwise to lock the lens in place.
e.Connect the lens cable to the lens connector 4 at the right side of the camera.
f.Place the lens cable into the bottom clip at the front of the camera and clip 5 located at the side. (Pull and twist clip 5 to open it.)
g.Select the lens type in the Lens menu. Set the Lens Type item to Std for a standard lens or to WA if an wide angle lens is mounted.
h.Select the lens manufacturer in the Lens menu. Select Ang for Angenieux, Can for Canon, Fuj1 or Fuj2 for Fujinon or select Other for other lens manufacturers.
CAUTION
Do not attach a lens weighting more than 5 kg to the camera without a support.
When a new lens is fitted to the camera it may be necessary to carry out some adjustments to optimize its use, for example, back focus or shading. For more information about these adjustments refer to Section 5 and to the lens manufacturer’s documentation.
Note: Always mount the dust protection cap when the lens is not connected to the camera.
Assembling the Units | Operator’s Manual LDK 200 Triax |