GE PTZ 12X manual Setting the communication DIP switches, To set the dome camera protocol

To set the dome camera protocol

1.Locate the protocol DIP switch block (A, Figure 1).

2.Set the DIP switch sequence for the desired protocol. See Table 2 below for the most frequently used protocol settings. For other supported protocols, please refer to the user manual.

Table 2: Dome camera protocols supported

GE Impac RS-485 (Baud rate: 9600)

GE Digiplex RS-422 (Baud rate: 4800)

Setting the communication DIP switches

See Figure 1 for the location of the communication DIP switches. The RS-485 default setting is half-duplex (see Figure 2 below.) For further information on the other options available, please refer to the user manual.

Figure 2: Default setting of RS-485 communication switch (half-duplex)