GE PTZ 12X manual To wire the dome camera

To wire the dome camera

1.Connect the 22-pin connector of the I/O interface cable to its connector in the base of the dome camera. See Figure 1 for its location.

2.Connect the crimp-on BNC connector of the video output to the coaxial video cable of a monitor or DVR.

3.Connect the control keyboard to the dome camera through the serial terminal block.

4.Connect the alarm cable to a dry contact. For example, a PIR detector, or an access control system.

5.Connect the RS-485 serial data connector to the DVR/keypad, as shown below.

Figure 5: 2-wire connection from a DVR/control keypad/PC to the dome camera

6.Connect the power cable to the power source. As soon as the dome camera is connected, it is operational.

Note: The ground wire must be inserted into the center pin of the power input terminal block. See Figure 6 on page 15.