Honeywell HD4UX Connecting Cables Through the Side Conduit, Cable Connection Through Side Conduit

Page 10

Connecting Cables Through the Side Conduit

1.Peel back the bottom flat gasket below the side conduit just enough to expose the security screw.

2.Use the supplied Allen key to loosen and remove the security screw (see Figure 2).

3.Use a flat screwdriver to unscrew the conduit plug.

4.Pull the cables through the hole.

5.Apply appropriate sealant around the opening to prevent moisture from entering the housing.

Figure 2 Cable Connection Through Side Conduit

side conduit

security screw

Allen key (supplied)

10

Image 10
Contents Day/Night Ultra Wide Dynamic Fixed Dome Camera Issue Date Revisions RevisionsElectric Shock COVER. no USER-SERVICEABLEQualified Service Personnel Do not OpenFCC Compliance Statement Contents Before You Begin IntroductionUnpack Everything Equipment Required Installation Mounting the CameraConnecting Cables Through the Housing Base Cable Connection Through GrommetConnecting Cables Through the Side Conduit Cable Connection Through Side ConduitElectrical Box Installations 4S Electrical Box InstallationPage Connecting the Wiring Adjusting the CameraAdjusting the Lens Focus Gimbal AdjustmentCamera Functions Camera SetupOSD Menu Structure Configuring the WDR Presets MenuOptimizing the Camera Setup DIG Slow Shutter CustomWhite Balance SyncAGC AWBSetting the Camera Image Properties AI TholdID Position ResolutionFlip UP-LEFT,UP-CENTER,UP-RIGHT,DOWN-LEFT,DOWNTDN Delay Setting the Day/Night ControlCLR Burst Restoring Settings Installing the Enclosure Cover Routine MaintenanceSolving Common Technical Issues Warranty and Service Video Signal Specifications SpecificationsElectrical Specifications Mechanical Specifications DimensionsRegulatory Cable Guidelines Maximum Video Coaxial Cable Length feet/metersHD4U Mounting Template Page Document 800-00031 Rev a 04/08 Honeywell Security Asia Pacific