JAI CV-M532 operation manual VR4 VR3 VR5, Adjustment of Video Signal Output Level

Page 20

CV-M532

8. Adjustment of Video Signal Output Level

When an alignment of a video output signal is required, remove the camera housing and adjust potentiometers VR3, VR4 and VR5 on the PK8056 board while measuring their levels at the video output connector.

This adjustment should only be done in a setup with a standard TV test chart and controlled illumination.

VR3: To adjust the gain level of AGC. (Factory setting: 700 mVp-p ± 30 mV)

VR4: To adjust the white level. (Factory setting: 800 mVp-p ± 20 mV)

VR5: To adjust the black level. (Factory setting: 20 mVp-p ± 5 mV)

CAUTION.

Do not touch these potentiometers unless you are familiar with camera adjustments.

Location of VR3 to VR5 on PK8056 board is as follow.

VR4VR3VR5

- 19 -

Image 20

Contents CV-M532 Declaration of Conformity Table of Contents General Standard CompositionMain Features Locations and Functions Type HR10A-7R-6PB Hirose male Seen from rear Pin Multi-connector DC-IN/SYNCPin Assignment Input/Output of HD/VD Signal Normal Shutter ModeExternal Trigger Mode Functions and OperationsEIA Non-interlaced / Field accumulation mode Edge pre-select mode for non-interlace onlyPulse Width Control Mode Pulse width control mode for non-interlace only Start/Stop Trigger Mode CV-M532 Long Time Exposure Mode EIACV-M532 Table for Shutter Time Mode SettingTable for SW 1 Setting SW2 on PK8057 Board Jumper Settings Pixel Clock OutputBoard PK8057 Side a Location of SW2 and JumpersBoard PK8054 Side B Adjustment of Video Signal Output Level VR4 VR3 VR5Head External AppearanceCCU Specifications Spectral SensitivityAppendix PrecautionsTypical CCD Characteristics Users Mode Settings Users Modifications User’s RecordCamera type CV-M532 Scanning system Revision Revision E Serial No