JAI CV-M532 operation manual Pin Assignment, Pin Multi-connector DC-IN/SYNC

Page 7

CV-M532

5. Pin Assignment

5.1.12-pin Multi-connector (DC-IN/SYNC.)

Type: HR10A-10R-12PB (Hirose) male Seen from rear.

Pin1no.

Signal

Remarks

5

GND

ParallelwiththeBNCvideooutput.Avoiddoubletermination.

423

+12VideoDCinput

67

HDVinput/output

HDVinasfactorysetting.*1)*2)

8

+12VGNDNCDCinput

NCasfactorysetting.Pixelclockoutput.*1)

1290

Notes:

*1) Signals on pin no. 6, 7 and 9 can be changed by jumper setting. See “7.3. Jumper Settings” for more information.

*2) In Edge Pre-select and Pulse Width Control mode do not input ext. VD signal.

5.2. 6-pin Multi-connector (TRIGGER)Pin21no.

EENSignalNCoutput

*Note

Remarks

Type: HR10A-7R-6PB (Hirose) male

 

 

 

Seen from rear.

6435

ExtWEN.TrigGNDNCoutputinput

*Note

 

* Notes:

The functions available on the 6-pin multi-connector are not effective in long time exposure mode.

- 6 -

Page 6 Page 8
Image 7
Page 6 Page 8
Contents CV-M532 Declaration of Conformity Table of Contents Standard Composition GeneralMain Features Locations and Functions Pin Assignment Pin Multi-connector DC-IN/SYNCType HR10A-7R-6PB Hirose male Seen from rear Functions and Operations Input/Output of HD/VD SignalNormal Shutter Mode External Trigger ModeEdge pre-select mode for non-interlace only EIA Non-interlaced / Field accumulation modePulse Width Control Mode Pulse width control mode for non-interlace only Start/Stop Trigger Mode CV-M532 EIA Long Time Exposure ModeCV-M532 Table for SW 1 Setting Mode SettingTable for Shutter Time SW2 on PK8057 Board Pixel Clock Output Jumper SettingsBoard PK8054 Side B Location of SW2 and JumpersBoard PK8057 Side a VR4 VR3 VR5 Adjustment of Video Signal Output LevelCCU External AppearanceHead Spectral Sensitivity SpecificationsTypical CCD Characteristics PrecautionsAppendix Revision Revision E Serial No Users Mode Settings Users ModificationsUser’s Record Camera type CV-M532 Scanning system
Top Page Image Contents