JAI CV-M532 operation manual Locations and Functions

Page 6

CV-M532

4. Locations and Functions
4-1. CCU1			7		23		4
			7		5	6
4-2. HEAD		8	9	10	11
1	12P connector			: To connect camera head with camera control unit
	(For Camera Head)
2	Video output connector			: To output video VS1.0Vp-p
	(BNC connector)
3	SW1 switch			: To set shutter speed and function modes
4	6-pin Multi connector			: Output WEN/EEN signal and input external trigger pulse, etc.
5	GAIN			: To adjust gain level
6	12P Multi connector			: Input DC+12V power and input/output of HD/VD signal, etc.
7	Screw holes for Tripod mount plate : To fix tripod mount plate (optional) on camera
8	CCD sensor			: 1/3" Hyper HAD Interline transfer CCD sensor
9	Focus adjustment ring			: To adjust lens focus
10	Camera head
11	connector			: To connect camera head with camera control unit

- 5 -

Image 6

Contents CV-M532 Declaration of Conformity Table of Contents General Standard CompositionMain Features Locations and Functions Pin Multi-connector DC-IN/SYNC Pin AssignmentType HR10A-7R-6PB Hirose male Seen from rear External Trigger Mode Input/Output of HD/VD SignalNormal Shutter Mode Functions and OperationsEIA Non-interlaced / Field accumulation mode Edge pre-select mode for non-interlace onlyPulse Width Control Mode Pulse width control mode for non-interlace only Start/Stop Trigger Mode CV-M532 Long Time Exposure Mode EIACV-M532 Mode Setting Table for SW 1 SettingTable for Shutter Time SW2 on PK8057 Board Jumper Settings Pixel Clock OutputLocation of SW2 and Jumpers Board PK8054 Side BBoard PK8057 Side a Adjustment of Video Signal Output Level VR4 VR3 VR5External Appearance CCUHead Specifications Spectral SensitivityPrecautions Typical CCD CharacteristicsAppendix Camera type CV-M532 Scanning system Users Mode Settings Users ModificationsUser’s Record Revision Revision E Serial No