JAI CV-M530, CV-M531 operation manual Jumper Settings, Pixel Clock Output

CV-M530/531

7.3. Jumper Settings

Caution on Jumper Setting.

Before making any mode or jumper setting turn the power OFF.

Jumpers for mode setting are found on the boards PK8054 & PK8057.

The following modes are available with jumper setting:

Input/Output Mode of HD/VD signal. (HD/VD input is factory setting)

Edge Pre-select Mode. (Factory setting)

Pulse Width Control Mode

Start/Stop Trigger Mode

Long Time Exposure Mode

Set the jumpers according to the list below in 7.3.1. and 7.3.2.

The jumper positions are shown in “7.4.1. Bo rd 8054 Side B” and “7.4.2. Board 8057 Side A”.

SwitchJumperSW2 onHD/VDExtHD/VDPK8057. in/outHD/VDisInt.shownEdgeselectinpre“7-.2.ExternalSW2widthPulseontriggerPK8057Start/modesstopBoard”Longexposetime.				Remarks
7.3.R127. JumperinputShorton *)PK8054outputShortBoard Short	controlShort	triggerOpen	Short	FactorysetSHORT

7.3.2. Jumper onHD/VDPK8057in/outBoard						Externaltriggermodes			Longtime		Remarks
Jumper		HD/VDExt.	HD/VDInt.	Edgepre-		widthPulse	Start/stp			HD
	21	input*)	output		select	control	trigger		expose
*) Factory Setting
	43	Short	Open		Short	Short	ShortOpen		Open	VDinput/output..Factorysetinput
JP89657			Short						Short	Longtimeintegration
JP	0	Open	Open		Open-	-		-	Open-	Pixelclockout.FactorysetOPEN
		Short	Short		Short	Open	Short		Short	Pulsewidth
SW12-21		ON	-		ON	ON	ON		ON	HDVin75Ohmterm.FactorysetON

*) Factory Setting

7.3.3. Pixel Clock Output

To use pixel clock output (TTL level: 4.0 V), make the jumper JP11 on PK8057 board shorted-circuited. The jumper position is shown in “7.4.1. Board PK8057 Side A”.

Pixel clock pulse will be output from pin no.9 of 12-pin multi-connector.

Caution for Pixel Clock Output.

When the pixel clock is enabled, it may cause interference with external equipment if it not properly shielded.

- 17 -