JAI CV-M530, CV-M531 operation manual 235, Locations and Functions

Page 6

CV-M530/531

4. Locations and Functions				235	64
	1		7	235	64
4-1. CCU			7
4-2. HEAD		8	10	9
1	12P connector		: To connect camera head with camera control unit
	(For Camera Head)
2	Video output connector		: To output video VS1.0Vp-p
	(BNC connector)
3	SW1 switch		: To set shutter speed and function modes
4	6-pin Multi connector		: Output WEN/EEN signal and input external trigger pulse, etc.
5	GAIN		: To adjust gain level
6	12P Multi connector		: Input DC+12V power and input/output of HD/VD signal, etc.
7	Screw holes for Tripod mount plate : To fix tripod mount plate (optional) on camera
8	CCD sensor		: 1/2" Hyper HAD Interline transfer CCD sensor
9	Camera head mount		: To mount camera head
10	Camera head connector		: To connect camera head with cable

- 5 -

Image 6

Contents CV-M530/531 Declaration of Conformity Table of Contents General Standard CompositionMain Features 235 Locations and FunctionsPin Multi-connector DC-IN/SYNC Pin AssignmentType HR10A-7R-6PB Hirose male Seen from rear External Trigger Mode Input/Output of HD/VD SignalNormal Shutter Mode Functions and OperationsEIA Non-interlaced / Field accumulation mode Edge pre-select mode for non-interlace onlyCcir Non-interlaced / Field accumulation mode Pulse Width Control ModePulse width control mode for non-interlace only Start/Stop Trigger Mode CV-M530/531 Long Time Exposure Mode EIA CcirCV-M530/531 Mode Setting Table for SW 1 SettingTable for Shutter Time SW2 on PK8057 Board Jumper Settings Pixel Clock OutputLocation of SW2 and Jumpers Board PK8054 Side BBoard PK8057 Side a Adjustment of Video Signal Output Level External Appearance CCUHead Specifications Spectral SensitivityPrecautions Typical CCD CharacteristicsAppendix Camera type CV-M530/531 Scanning system Users Mode SettingsUser’s Record Revision Revision E Serial No