JAI CV-M531, CV-M530 operation manual Appendix, Precautions, Typical CCD Characteristics

Page 23

CV-M530/531

11. Appendix

11.1. Precautions

Personnel not trained in dealing with similar electronic devices should not service this camera.

The camera contains components sensitive to electrostatic discharge. The handling of these devices should follow the requirements of electrostatic sensitive components.

Do not attempt to disassemble this camera.

Do not expose this camera to rain or moisture.

Do not face this camera towards the sun, extreme bright light or light reflecting objects. Even when this camera is not in use, put the supplied lens cap on the lens mount.

Handle this camera with the maximum care.

Operate this camera only from the type of power source indicated on the camera.

Power off the camera during any modification such as changes of jumper and switch setting.

11.2. Typical CCD Characteristics

The following effects may be observed on the video monitor screen. They do not indicate any fault of the CCD camera, but do associate with typical CCD characteristics.

V. Smear

Due to an excessive bright object such as electric lighting, sun or strong reflection, vertical smear may be visible on the video monitor screen. This phenomenon is related to the characteristics of the Interline Transfer System employed in the CCD.

V. Aliasing

When the CCD camera captures stripes, straight lines or similar sharp patterns, jagged image on the monitor may appear.

Blemishes

Some pixel defects can occur, but this does not have en effect on the practical operation.

Patterned Noise

When the CCD camera captures a dark object at high temperature or is used for long time integration, fixed pattern noise (shown as white dots) may appear on the video monitor screen.

- 22 -

Image 23
Contents CV-M530/531 Declaration of Conformity Table of Contents Standard Composition GeneralMain Features Locations and Functions 235Type HR10A-7R-6PB Hirose male Seen from rear Pin Multi-connector DC-IN/SYNCPin Assignment Functions and Operations Input/Output of HD/VD SignalNormal Shutter Mode External Trigger ModeEdge pre-select mode for non-interlace only EIA Non-interlaced / Field accumulation modePulse Width Control Mode Ccir Non-interlaced / Field accumulation modePulse width control mode for non-interlace only Start/Stop Trigger Mode CV-M530/531 EIA Ccir Long Time Exposure ModeCV-M530/531 Table for Shutter Time Mode SettingTable for SW 1 Setting SW2 on PK8057 Board Pixel Clock Output Jumper SettingsBoard PK8057 Side a Location of SW2 and JumpersBoard PK8054 Side B Adjustment of Video Signal Output Level Head External AppearanceCCU Spectral Sensitivity SpecificationsAppendix PrecautionsTypical CCD Characteristics Revision Revision E Serial No Users Mode SettingsUser’s Record Camera type CV-M530/531 Scanning system