CV-A1
5. Pin Assignment
5.1.12-pin Multi-connector (DC-IN/VIDEO OUT, EXT.HD/VD IN)
Type:
|
| Seen from rear | Pin configuration is compatible with EIAJ standard | |||||
|
|
|
|
| Pin no. | Signal | Remarks | |
|
|
|
|
| 1 | GND |
|
|
|
| 1 | 9 |
| 2 | +12 V DC input |
|
|
|
|
| 3 | GND |
|
| ||
| 2 | 10 |
| 8 |
|
| ||
|
| 4 | Video output | Parallel with the BNC connector. | ||||
|
|
|
| |||||
3 |
| 11 | 12 | 7 | ||||
| 5 | GND |
|
| ||||
|
| 4 |
| 6 |
|
| ||
|
|
| 6 | HD input/HD output | *) | SW2.1 on for 75Ω. SW1.1 on for HD out. | ||
|
| 5 |
|
| ||||
|
|
|
|
| 7 | VD input/VD output | *) | SW2.2 on for75Ω. SW1.2 on for VD out. |
|
|
|
|
| 8 | GND |
|
|
|
|
|
|
| 9 | Pixel clock output | *) | JP2 short and PC=1 for pclk out. |
|
|
|
|
| 10 | WEN output | *) | GND if JP5 open and JP3 short |
|
|
|
|
| 11 | Trigger input | *) | +12V DC if JP1 short and JP4 open |
|
|
|
|
| 12 | GND |
|
|
Fig. 2. 12-pin connector.
Plugs for cable: HR10A-10P-12S
5.2.6-pin Multi-connector (TRIGGER)
Type:
Seen from rear.
|
| Pin no. | Signal | Remarks | |
|
| 1 | TXD out |
|
|
1 | 6 | 2 | RXD in |
|
|
2 | 5 | 3 | GND |
|
|
3 | 4 | 4 | GND |
|
|
|
| 5 | Trigger input | *) | Parallel with pin 11 on 12 pin con |
|
| 6 | EEN output | *) | *2). WEN output if EW=1 |
Fig. 3. 6-pin connector.
Notes. | Plugs for cable: |
| |
*) | Alternative signals can be placed on these pins by switch or jumper settings or |
| |
| Configurations shown in Bold + italic is factory setting. |
*2) | EEN will be low all the time in normal continous mode (TR=0), if the selected |
| exposure time is longer than the frame readout time. |
- 4 -