Hitachi 21, BE-IR20 manual Installation, Two 2.5 mm Dia

Page 8

8.Installation

When installing the camera in a housing or unit of equipment, secure with two M2 screws inserted into the 2.5 mm diameters holes of the SENS board base plate.

Two 2.5 mm Dia.

SENS board

1.Use the SENS board holds to install the camera. Avoid using only the Main board,

Notes : due to risk of damage to the board connector.

2.Avoid unnecessary stress on the printed board when engaging and disengaging the connectors.

3.The screws securing the base plate and SENS board protrude a maximum of 2 mm from the base plate. Observe these screws do not contact the housing or installed equipment.

BE-IR20 / 21

Image 8

Contents Infrared B/W Camera Module Operation Guide Table of Contents Specifications IntroductionGeneral Composition．Specifications BE-IR20 BE-IR20 Optical dimensions External viewInstallation Two 2.5 mm DiaTypical connection BLK GRN YEL REDTypical connection GNDExternal sync BE-IR21 Function setting and changes AGC on / offFunction setting and changes Gamma responseAuto electronic shutter on / off Changes to fixed shutter mode FixedBE-IR20 external sync BE-IR21 internal sync HD and VD output BE-IR20 only Options BE-IR20/21 and LA-IR20 combined dimensions OptionsSpectral sensitivity typical example U t i o n