Hitachi 21 manual HD and VD output BE-IR20 only

Page 18

11. Function setting and changes

11-7 HD and VD output (BE-IR20 only)

The BE-IR20 can be provided with horizontal and vertical drive outputs by changing chip parts. Change the following chip parts to provide HD and VD outputs.

	R233	R239	R240	R241		R242	R248	R249	R250
Factory setting	0 Ω	Absent	0 Ω	Absent		0 Ω	Absent	0 Ω	Absent
HD & VD output	Delete	0 Ω	Delete	0 Ω		Delete	0 Ω	Delete	0 Ω
0 Ω ：	Part code		RME1784
	Type		ERJ3GEYJ0R00V

Connector pin assignments after change

Pin No.	Signal
１	Video out
２	Video GND
３	GND
４	+9V
５	HD out
６	VD out
７	HD/VD GND

Note: The accessory cable cannot be used for signal outputs.

Location of chip resistors(Main board side B)

BE-IR20 / 21

17

Image 18

Contents Infrared B/W Camera Module Operation Guide Table of Contents General SpecificationsIntroduction Composition．Specifications BE-IR20 BE-IR20 Optical dimensions External viewInstallation Two 2.5 mm DiaTypical connection BLK GRN YEL REDTypical connection GNDExternal sync BE-IR21 Function setting and changes AGC on / offFunction setting and changes Gamma responseAuto electronic shutter on / off Changes to fixed shutter mode FixedBE-IR20 external sync BE-IR21 internal sync HD and VD output BE-IR20 only Options BE-IR20/21 and LA-IR20 combined dimensions OptionsSpectral sensitivity typical example U t i o n