Hasselblad 3034216 Default APPR. Level, To change the default status assigned to each new image

1



2



3



6

DEFAULT APPR. LEVEL

The Instant Approval Architecture system helps you to evalu- ate and mark each image based on how well it has come out. By default, the system assigns an initial approval status for each new shot based on an analysis of the distribution of exposure levels. In the factory configuration, the status of each new shot is assigned as follows:

•Green (approved):

The new shot seems to have been exposed correctly.

•Yellow / Amber (unclassified):

The new shot seems to have been over- or under-exposed.

However, you might choose instead to override this system and have all new shots assigned either as green or yellow, regardless of the exposure analysis results. A typical strategy could be to as- sign all shots to yellow and then review all of the shots later and promote only the best ones to green status. At the same time you might demote the most doubtful shots to red status.

See also Using Instant Approval Architecture for complete details about working with the approval system.

To change the default status assigned to each new image:

1.Press the MENU button.

2.Press  to navigate down and select the Storage level.

Press  and then  to navigate down and select Default Appr. level. Press  to open the Default Appr. level dialog.

3.Use the or button to step through the available set- tings until the default status you wish to use (auto, green or yellow) is shown.

3.Either move on to another setting by using the navigator but- ton or press the menu (EXIT) button to exit the menu system and keep your setting.

43