EverFocus EZ650 manual RS485 ID & Baud Rate Setting

3.2 RS485 ID & Baud Rate Setting

Note: This section is optional preserved for the people that want to change camera ID and baud rate. In most situations, we suggest you can just use Camera ID-01 and Baud Rate-9600, Protocol-Pelco D on keyboard, then it would work.

I. Please turn the control key selection switch at back panel to “OSD”( ).

II. Press the mini-joystick for 4 seconds until you see the following menu.

A B C D E F G H I J K L M

N	O P	Q R		S	T	U	V	W X	Y	Z
a	b c	d	e	f	g	h	i	j k	l	m
n	o p	q	r	s	t	u	v	w x	y	z
─ ·		0	1	2	3	4	5	6 7	8	9
← →		C	L	R		P	O S		E	N D
F I R M W A				R	E	_+ V E R _ _ _

III.Turn the mini-joystick up () or down () to adjust setting, press mini-joystick to go next selection.

IV. Please wait 3 seconds after setting any item, it will automatically switch to next setting item.

V. Camera setting order:

a. Firmware version. VER_xxx- shows the current firmware version.

23