EverFocus EZ650 manual Cable Clips

8.Connect RG59 coaxial cable with BNC connector.

9.Unscrew both cable clips, wire power cable and RS485 cable through the cable clips. Then, screw the cable clips to rear panel.

a.Connecting Power-24VAC model: connect 24VAC power on N and L 100VAC~240VAC Model: Connect PE, N and L.

*Warning*

∙To prevent electrical shock, turn off the electrical power before making electrical connections.

∙Do not connect high voltage power to the camera. It may damage the camera.

∙Do not short circuit the power leads and expose the wire when connecting the power supply to the camera.

b.Connect Video- Make sure connecter is firmly connected.

c.Connecting RS485 (optional): Connect RS585 cable to 485+ and 485-. Please use screw driver to lose and tight the screw on the RS485 terminal pin when you do connection.

Power cable

Coaxial cable

RS485 cable

Cable Clips Cable Clips

10.Close the back cover and screw the 2 screws firmly. Now, you are done with the installation. NOTE: Before you close the cover, please make sure control key is attached firmly and wire doesn’t stuck.

17