EverFocus EZ650 manual FederalCommunicationCommissionInterferenceStatement

Page 4

FederalCommunicationCommissionInterferenceStatement

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of the following measures:

-Reorient or relocate the receiving antenna.

-Increase the separation between the equipment and receiver.

-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

-Consult the dealer or an experienced radio/TV technician for help.

FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this equipment.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

4

Image 4
Contents IR Day/Night plus Wide Dynamic Range IP66 Bullet Camera N4605XZ0650001AR OperationInstruction Precautions FederalCommunicationCommissionInterferenceStatement Table of Contents Features ProductOverviewAccessory Parts List Specifications 3D-DNRDrilling Dimension of holes to holes DimensionsDimension of Bracket Dimension of whole camera with bracket Dimension of whole camera with bracket and EPR100Camera Component Description Back Panel Layout 12VDC GNDRelated Products Installation Wiring and MountingFix the bracket to wall by using 4 screws Page Page Cable Clips Adjusting Camera Position Adjusting Lens Lens SettingKeyboard Connection Optional Control Key General Operation Guide VI. Return to Previous VII. Close the Host Menu ScreenRS485 ID & Baud Rate Setting U D T a OSD Menu Setup OSD MenuTreeOff INT / LL English Trad. Chinese Simp. Chinese Japanese Shutter SENS-UPDefault BLCGain LEFT/RIGHTWDR LevelOFF ATW AWBAWC -SET ManualDelay ColorAuto LevelFlip MirrorRotate Pan TiltArea Select Area DisplayPrivacy SyncINT Internal synchronization8.3 RED BlueExit Key Features with Keyboard OSD Menu Setting by KeyboardLens Adjustment by Keyboard EverFocus Taiwan EverFocus China BeijingEverFocus USA California EverFocus Japan