| Hardware Installation |
Hardware Installation
Attach the Antenna
Locate the antenna included with your
Note: It is required that an Ethernet cable is used during initial setup. Once your wireless configuration is set, you may disconnect the Ethernet cable and begin communicating wirelessly with your
Attach the Swivel Stand
Locate the stand mount on the bottom panel of the
Connect the Ethernet Cable
Connect the included Ethernet cable to the network cable connector located on the back panel of the
Attach the External Power Supply
Attach the external power supply to the DC power input connector located on the rear panel of the
Note: Power source is confirmed when the red LED Power Indicator located to the right of the lens on the
10 |