Option unit connection
Camera disassembly
1)Remove top cover.
Take out 5 screws and remove the top cover [A].
2)Remove the PROC/MEN unit [B].
Take out 2 screws and disconnect 3 flat cables. | Raise the board towards the lens |
side and slide it forward to remove the board. |
|
3) Remove the REG/SG unit [C]. |
|
Take out 2 screws and disconnect 1 flat cable. | Remove the lead connector [E],[D]. |
Raise the board towards the lens side and slide it forward to remove the board.
Notes:
1.Release the connector lock mechanism when disconnecting the flat cables.
2.Do not open the connector lock lever more than 90 degrees(lever can be damaged).
2 wire unit and adaptor board assembly
Assemble the 2 wire unit and adaptor board, then install in the camera.
1)Overlap the 2 wire unit [F] and adaptor board [G], then secure with 2 screws and threaded plate [H].
2)Engage lead connector [I] with the 2 wire unit [F].
39