Note: Select from among 8 areas when using a DC control voltage input type lens; select from among 3 horizontal areas (dotted outline in figure) when using a video signal input type lens.
Sensing area positions
•Video level setting
Set the video level only when using a DC control voltage input type lens. The factory setting is standard.
To change the setting, press the left (right) direction button, adjust the video level, then press the Set button. If the setting is not to be changed, press the Set button and shift to RET.
Light control menu
Note: If using a video signal input type lens, refer to the lens operating instructions and adjust the lens sensitivity.
Photometric area setting screen
The standard area No.1 is set at factory. When the set button is pressed while No.1" is blinking, the critical photometric area is displayed. The critical photometric area is indicated by dots. When this area is changed, a video signal level is changed according to the illumination of this area.
The desired photometric area can be selected from among the areas No.1 thru No.8. Therefore, select the photometric area so that the optimum video signal level can be obtained.
18