CHECKING BATTERY POWER
Pull out the film advance lever 1. 74 to unlock the shutter release button 70 . The lever doubles as a shutter release button lock.
Depress the shutter release
2. button halfway to activate the exposure meter.
Check the LCD. Confirm that the
3. LCD (liquid crystal display) is shown at the upper left in the viewfinder. This indicates that battery installation is correct and power is sufficient. If necessary, replace with a
new set.
With sufficient battery power, the LCD stays on for 16sec. after you take your finger off the button. If the batteries are almost depleted, the LCD will turn off immediately when you take your finger off the button. In this case, replace batteries as soon as possible. With exhausted batteries, you cannot trip the shutter unless the shutter speed dial 75 is set at a mechanical setting of M250 or B.
•The LCD does not appear when the shutter dial is set at M250 or B
WWW.LENSINC.NET / | 9 |