Yamaha RX-V559 owner manual Recording, Mdsleep

RECORDING

Recording adjustments and other operations are performed from the recording components. Refer to the operating instructions for those components.

CAUTION

The DTS signal is a digital bitstream. Attempting to digitally record the DTS bitstream will result in noise being recorded. Therefore, if you want to use this unit to record sources encoded in DTS, the following considerations and adjustments need to be made. To play DTS-encoded DVDs and CDs (when using a digital audio connection) on your DTS-compatible player, follow its operating instructions to make a setting so that the analog signal will be output from the player.

Notes

•When this unit is set to the standby mode, you cannot record between other components connected to this unit.

•The settings of TONE CONTROL (see page 32), VOLUME, the speaker level (see page 80) and the sound field programs (see page 64) do not affect the recorded material.

•The source connected to the MULTI CH INPUT jacks of this unit cannot be recorded.

•S-video and composite video signals pass independently through the video circuits of this unit. Therefore, when recording or dubbing video signals input from a video source component that provides only an S-video or a composite video signal, you can record only an S-video or a composite video signal on your VCR.

•Digital signals input at the DIGITAL INPUT jacks are not output at the analog AUDIO OUT (REC) jacks for recording. Likewise, analog signals input at the AUDIO IN or PORTABLE jacks are not output at the DIGITAL OUTPUT jack. Therefore, if your source component is connected to provide only digital or analog signals, you can only record digital or analog signals.

•A given input source is not output on the same OUT (REC) channel.

•Check the copyright laws in your country to record from CDs, radio, etc. Recording of copyrighted material may infringe copyright laws.

•The XM Satellite Radio (U.S.A. model only) signals cannot be output at the AUDIO OUT (REC) jacks.

•The analog audio signals input at the DOCK terminal can be output at the analog AUDIO OUT (REC) jacks for recording.

y

Do a test recording before you start an actual recording.

If you play back a video source that uses scrambled or encoded signals to prevent it from being dubbed, the picture itself may be disturbed due to those signals.

							(U.S.A. model)
								VOLUME
						ZONE 2	ZONE
						ON/OFF	CONTROL
MASTER			PRESET/TUNING FM/AM	A/B/C/D/E	l PRESET/TUNING/CH h	MEMORY TUNING MODE
			EDIT
			SEARCH MODE	CATEGORY		DISPLAY
ON OFF
			PROGRAM			INPUT
MAIN ZONE
PHONES	SPEAKERS
	A	B	STRAIGHT	TONE CONTROL	INPUT MODE	MULTI CH
						INPUT		VIDEO AUX
ON/OFF							VIDEO	L AUDIO R	PORTABLE

EFFECT

SILENT CINEMA

1Turn on all the connected components.

2Rotate the INPUT selector on the front panel (or press one of the input selector buttons on the remote control) to select the source component you want to record from.

MDSLEEP

INPUT

2

CODE SETTRANSMIT

	POWER	POWER	STANDBY	POWER
	TV	AV
		MD		SLEEP
2	CD	CD-R	XM
		CBL		MULTI CH IN
	DVD	DTV	TUNER

V-AUX DVR

AMP

SOURCE

TV VOL TV CH VOLUME

TV

(U.S.A. model)

	CD	CD-R	XM
		CBL	MULTI CH IN
or	DVD	DTV	TUNER
	V-AUX	DVR
Front panel		Remote control

3Start playback on the selected source component or select a broadcast station.

4Start recording on the recording component.

44