Oregon Scientific PV 100 user manual Using the SELF-TIMER

EN

NOTE: In Movie Mode, once the SHUTTER RELEASE button is pressed and recording starts, zooming cannot be further adjusted for the duration of the recording.

USING THE SELF-TIMER

The Self-Timer function counts down 10 seconds before the camera automatically takes a picture by itself. This is useful when you want to be in the picture and there is no one else to press the SHUTTER RELEASE button.

1.Slide the Mode Switch to Record Mode.

2.Use and press to activate the Self-Timer function. The Self- Timer lamp at the front of the camera beside Lens lights up and the Self-Timer icon appears on the LCD.

TIP: If you wish to cancel the Self-Timer function at this stage, press again and the icon on the LCD will disappear.

3.Press the SHUTTER RELEASE button. Audible beeps can be heard and the Self-Timer lamp will start blinking. The number displayed next to the LCD’s Self-Timer icon will appear and start counting down from 10 seconds to 0 seconds.

4.Press the SHUTTER RELEASE button again anytime during count down between 10 seconds to 4 seconds and the Self- Timer will jump to count down from 3 seconds to 0 seconds.

TIP: Press the SHUTTER RELEASE button at this stage during count down from 3 seconds to 1 second to cancel the Self-Timer function.

NOTE: The Self-timer is set to start count down from 10 seconds only.

NOTE: Once a picture has been taken, the Self-Timer will automatically disable.

9

PV100 Eng R7 a OP 10 9/9/04, 2:45 PM