Oregon Scientific PV 100 user manual Installing and Charging the Batteries, Attaching the Strap

INSTALLING AND CHARGING THE BATTERIES

Your camera comes with a rechargeable Lithium-Ion (Li-Ion) battery. To prevent damage, correctly insert the battery as shown.

TIP: To maximize the performance of your camera and for greater battery life, control the use of the flash, photo review, and LCD brightness levels.

The camera's battery can be charged in a variety of ways:

A.Through the camera itself by connecting the AC adaptor through the PV100's DC jack.

B.By docking the camera into a PV100D cradle and connecting the AC adaptor through the DC jack.

C.By taking out the battery from the camera and inserting into the battery slot of the cradle for charging.

NOTE: It takes approximately 6 hours to fully charge the Li-Ion battery. The right LED (Refer to P.2) showing red means the camera is being charged. When the battery is fully charged, the right LED turns off.

NOTE: In a non-controlled environment, many factors can affect battery life such as temperature, use of the flash, photo review, LCD display brightness levels and so on.

ATTACHING THE STRAP

1. Pass the thin loop of the strap through the camera's strap ring.

2. Pass the other end of the strap through the loop.

3. Tighten by pulling the loop.

4

EN

PV100 Eng R7 a OP 5 9/9/04, 2:45 PM