Kodak EasyShare LS743 manual Picture quality problems

Troubleshooting

If...	Try one or more of the following
Slide Show does not	■ Adjust the camera Video Out setting (NTSC or PAL,
run on an external	page 20).
video device	■ Make sure the external device settings are correct (see the
	device’s user’s guide).
Picture quality problems

If...	Try one or more of the following
The picture is too dark	■ Use Fill flash (page 14) or change your position so light is
or underexposed	not behind the subject.
	■ Move so that the distance between you and the subject is
	within the effective flash range (see page 14).
	■ To automatically set exposure and focus, press the Shutter
	button halfway and hold. When the ready light glows
	green, press the Shutter button completely down to
	take the picture.
	■ Increase Exposure Compensation (page 16) and try again.
	■ Check if you are in Beach or Snow scene mode (page 10).
The picture is too light	■ Turn flash off (page 14).
	■ Move so that the distance between you and the subject is
	within the effective flash range (see page 14).
	■ To automatically set exposure and focus, press the Shutter
	button halfway and hold. When the ready light glows
	green, press the Shutter button completely down to
	take the picture.
	■ Decrease Exposure Compensation (page 16) and try
	again.
The picture is not clear	■ To automatically set exposure and focus, press the Shutter
	button halfway and hold. When the ready light glows
	green, gently press the Shutter button completely down
	to take the picture.
	■ Clean the lens (page 48).
	■ Make sure camera is not in Close-up mode if you are
	further than 39 in (100 cm) from your subject.
	■ Place the camera on a flat, steady surface or use a tripod.

40