Battery recharge Problem Cause/solution | Panasonic KX-TG6562E

TG6561E(e).book Page 46 Tuesday, July 13, 2010 1:50 PM

Useful Information

Problem	Cause/solution
I cannot activate the	L You cannot set eco mode when you set the repeater
eco mode.	mode “On”. If required, set the repeater mode to
	“Off” (page 30).
I cannot register a	L The maximum number of handsets (6) is already
handset to a base unit.	registered to the base unit. Cancel unused handset
	registrations from the base unit (page 30).
	L You entered the wrong PIN. If you forget your PIN, see
	“I cannot remember the PIN.” (page 46).
I cannot remember the	L Change the PIN using the following method.
PIN.	1 8i {#}{1}{3}{2}
	2 {*}{7}{0}{0}{0}
	3 Enter the new 4-digit base unit PIN. i Mi
	{ic}

Battery recharge

Problem	Cause/solution
The handset beeps	L Battery charge is low. Fully charge the batteries (page
and/or )flashes.	10).
I fully charged the	L Clean the battery ends (S, T) and the charge
batteries, but	contacts with a dry cloth and charge again.

–)still flashes or L It is time to replace the batteries (page 10).

–the operating time seems to be shorter.

The handset display is L The handset is not turned on. Turn the power on (page
blank.	14).

Making/answering calls, intercom

Problem	Cause/solution
_is displayed.	L The handset is too far from the base unit. Move closer.
	L The base unit’s AC adaptor is not properly connected.
	Reconnect AC adaptor to the base unit.
	L The handset is not registered to the base unit. Register
	it (page 29).
	L Activating one touch eco mode reduces the range of
	the base unit in standby mode. If required, turn eco
	mode off (page 15).

46Helpline Tel. No.: U.K. 0844 844 3898 R.O.I. 01289 8333

Image 46

Panasonic KX-TG6562E, KX-TG6561E Battery recharge Problem Cause/solution, Making/answering calls, intercom

Contents

Before initial use, see Getting Started on Introduction Caller ID ServiceVoice Mail Service Important Information Accessory item/Part number Quantity KX-TG6561 KX-TG6562 Accessory informationSupplied accessories Model composition Expanding your phone system Additional/replacement accessoriesSales and support information For your future reference General informationDeclaration of Conformity For your safety Important safety instructions Other information TG6561Ee.book Page 9 Tuesday, July 13, 2010 150 PM Battery charge Setting upBattery installation Connections Battery level Icon During a power failureOperation Operating time Handset ControlsBase unit Handset display items Meaning DisplaySoft key icons Icon Action Display language Turning the power on/offInitial settings Date and time One touch eco mode Wall mounting Making calls Using the handset Using the base unitService users Pause for PBX/long distance Answering calls Useful features during a callUsing the handset Hold Recall/flash MuteCall share Handset key lock Handset phonebook Copying an entry Copying phonebook entriesCopying all entries Adding phone numbers to speed dial Making a call using the speed dial keysBase unit speed dial To erase a stored phone number Programming by scrolling through the display menus Programmable settingsMain menu Sub-menu Display Setup Programming using the direct commands Feature Code Setting For the answering system Feature Code Setting Answer Off TG6561Ee.book Page 27 Tuesday, July 13, 2010 150 PM Changing the handset name AlarmSpecial programming Incoming call barring Caller ID subscribers only Changing the base unit PIN Personal Identification Number Increasing the range of the base unit Setting the repeater modeDeregistering a handset Caller list Using Caller ID serviceCaller ID features Viewing the caller list and calling back Erasing all caller information Editing a caller’s phone number before calling backErasing selected caller information Storing caller information to the phonebook Memory capacity including your greeting message Answering systemTurning the answering system on/off Call screening Greeting message Listening to messages using the base unitUsing a pre-recorded greeting message Recording your greeting message Erasing all messages Listening to messages using the handsetOperating the answering system during playback Operating the answering system Remote operation Remote access codeUsing the answering system remotely Calling back Caller ID subscribers only Turning on the answering system remotely Answering system settingsRemote commands Number of rings before the unit answers a call Caller’s recording time Selecting Greeting Only Voice mail service Transferring calls, conference calls IntercomHandset locator Making an intercom call To complete the transfer Press s To complete the transfer Press icTo establish a conference call Press w To establish a conference call Press Character entry When the unit displays the character entry screenCharacter entry modes Extended 1 character table N Extended 2 character table O Error messages Display message Cause/solution General use Problem Cause/solution TroubleshootingProblem Cause/solution Battery recharge Problem Cause/solution Making/answering calls, intercom Caller ID Problem Cause/solution Answering system Problem Cause/solution Own greeting message again Liquid damage Problem Cause/solution Conditions of guarantee Panasonic Business Systems U.K Index Sales Department Copyright