9. What do I do if (Trouble shooting)
No image appears on the screen
Possible causes and remedies:
1.The KODAK DP850 ULTRA is left in Standby mode. If the product is in standby mode, there will be a red light next to the
2.The lamp does not function. Check the light on the control panel. If the light is orange, the lamp does not function. Contact your KODAK dealer.
3.The product is set in ‘blank mode’. Press the zap keys on the remote control.
4.The brightness is turned on too low. Adjust bright- ness until a satisfactory image is achieved.
5.The power save or screen save on the PC is turned on. Turn off the power save and screen save on the PC.
6.The image is displayed on the laptop screen and not the projector. Activate the external port on the laptop by pressing the required key combination on your computer.
33
7.The KODAK DP850 ULTRA is not connected to electricity. Check that the power cable is connected to the KODAK DP850 ULTRA and the wall outlet.
No source signal is detected
(the KODAK Welcome Picture appears)
Possible causes and remedies:
1.The computer has not been switched on. Turn on the computer.
2.The cables are not properly connected. Check all cable connections.
3.For Notebooks: The external RGB port may need to be manually activated. Please consult the
Contents