Light & Motion HC3 manual Reversing Smart Grip Button Functions, Bluefin Monitors Getting Started

Page 13

Reversing Smart Grip Button Functions

Smart Grips can be programmed to swap left and right button functions. This is useful if a Smart Grip battery becomes exhausted during a dive.You then can swap Smart Grip functions to maintain primary housing operation.

This is a total button function swap, not a button-by-button nor a custom configuration.

1)Press either FAR/- and NEAR/+ or TELE and WIDE buttons simultaneously and hold for three seconds.

Button functions are now swapped. Button functions will mirror opposite handle,i.e. REC and PHOTO,AF/OFF and PHOTO DIS.

This is a handle-by-handle procedure. Performing this function on one handle will not switch both.

Revert to original button configuration

1)Perform the same swap procedure. Press either FAR/- and NEAR/+ or TELE and WIDE simultaneously and hold for three seconds.

Eventually the batteries in the Smart Grips will totally exhaust. Contact Light & Motion to order a replacement battery and O-ring kit (part #802-0117), or remove the Smart Grip handle cover and replace the two batteries located inside. Batteries are CR 1/3 N and can usually be purchased from any store that stocks camera and watch batteries.

Bluefin Monitors - Getting Started

Illustrated below are the components of the Compact Monitor and the Remote Monitor. Take time to identify and become familiar with each part.

Compact Monitor

Remote Monitor

 

Bulkhead

Lens Shade

Clamp Assembly

Monitor Cable

13

Image 13
Contents For the Sony HDR-HC3 camcorder Welcome Table of Contents Getting Started Camera Preparation Menu Setup Page Mounting the Camera Left Smart Grip Controls Refer fig OperationRear Plate Refer fig Smooth Slow Recording Lens Installation / Removal Using the Bluefin in VTR ModeBluefin Monitors Getting Started Reversing Smart Grip Button FunctionsAttaching the Remote or Compact Monitor Bluefin Monitor Bulkhead InstallationRemote Monitor Operation Compact Monitor OperationDiving Without a Monitor Attached Charging the Remote and Compact MonitorDisplay Icons on Monitors Bluefin Light Systems Getting Started Charging Batteries Installing BatteriesRemoving Batteries Connecting Lights to Battery Pods Mounting Battery PodsLight Operation Replacing Handle BatteriesPre-Dive Checklist Ring Care & Maintenance Housing StorageFirst Time Use After Diving CareLight & Motion European Service Center Other MaintenanceBluefin Accessories Light & Motion