Light & Motion HC3 Charging the Remote and Compact Monitor, Diving Without a Monitor Attached

Charging the Remote and Compact Monitor

1)Remove the Charging Port Plug using a coin or large flat head screwdriver. (Refer fig. 20)

2)Plug charger into a 110v outlet.

This charger is only rated at this voltage. If you do not have access to a 110v outlet, you must use a converter.

3)Plug charging connector from charger into charging port on Remote Monitor.

4)Charge for 8-14 hours, then remove charging cord.

5)Check O-ring on Charging Port Plug.

6)Replace Charging Port Plug.

Failure to re-install Charging Port Plug WILL flood the Monitor.

Diving Without a Monitor Attached

If you do not use the monitor you MUST de-activate power to the bulkhead before entering the water.

To de-activate BlueFin bulkhead:

1)Remove the Rear Plate.

2)Locate the power switch on the inside of the Rear Plate.

3)Move the switch to the OFF position.

Display Icons on Monitors

Monitor Screen

In order to see the camera display information in the monitor screen, you will need to set the camera to V-OUT/PANEL on the menu screen. Go to menu, scroll to STANDARD SET, highlight DISPLAY and set to V-OUT/PANEL (Refer Fig 21). Refer to your Sony instruction manual. If done correctly, the external monitor will now display all camcorder view finder information.

Charging Plug

(Fig. 20) (Fig. 21)

16