Light & Motion HC3 Bluefin Monitor Bulkhead Installation, Attaching the Remote or Compact Monitor

Page 14

Bluefin Monitor - Bulkhead Installation

1)Remove the Rear Plate.

2)Using a flat head screwdriver or coin, remove the Port Plug. (Refer Fig. 16)

3)On the inside of the Rear Plate, remove the four screws using a 3/32 allen key and remove circuit board. (Refer Fig. 17)

4)Feed Bulk Head cable through Bulk Head port. (Refer Fig. 18)

5)Insert Bulk Head into Rear Plate until it is firmly seated.

6)Tightening bulk head by turning the bulk head itself with a 3/4” wrench.

7)Attach Bulk Head Cable into the Primary Bulkhead connector on the inside of the Rear Plate circuit board. (Refer Fig. 19)

8)Replace circuit board and secure it to the Rear Plate using the four button head cap screws.

Button head cap screws

(Fig. 16)

(Fig. 18)

(Fig. 17)

(Fig. 19)

Attaching the Remote or Compact Monitor

1.Attach clamp assembly to back of monitor.

2.Attach monitor/clamp assembly to quick connect post by pressing down and rotating until black sleeve locks into position.

3.Adjust monitor by releasing clamp assembly (clockwise to tighten, counter clockwise to loosen).

4.Cable plugs are identical at each end. Attach by aligning the pins and pressing into the bulkhead until the black rubber seats.Turn locking sleeve clockwise to tighten.

14

Image 14
Contents For the Sony HDR-HC3 camcorder Welcome Table of Contents Getting Started Camera Preparation Menu Setup Page Mounting the Camera Operation Left Smart Grip Controls Refer figRear Plate Refer fig Smooth Slow Recording Using the Bluefin in VTR Mode Lens Installation / RemovalReversing Smart Grip Button Functions Bluefin Monitors Getting StartedBluefin Monitor Bulkhead Installation Attaching the Remote or Compact MonitorCompact Monitor Operation Remote Monitor OperationDisplay Icons on Monitors Charging the Remote and Compact MonitorDiving Without a Monitor Attached Bluefin Light Systems Getting Started Removing Batteries Installing BatteriesCharging Batteries Light Operation Mounting Battery PodsConnecting Lights to Battery Pods Replacing Handle BatteriesPre-Dive Checklist First Time Use Housing StorageRing Care & Maintenance After Diving CareOther Maintenance Light & Motion European Service CenterBluefin Accessories Light & Motion