Light & Motion HC3 Mounting Battery Pods, Connecting Lights to Battery Pods, Light Operation

Page 19

Mounting Battery Pods

1)Remove the rear plate of the housing.

2)Slide the battery pods into housing channels.

3)Insert Pod Locker between the pods and tighten using 1/8” allen key. Do not over-tighten.

Connecting Lights to Battery Pods

1)Plug in the cable connectors on the pod.

2)Tighten the locking sleeves by rotating clockwise until tight.

1)Plug in the cable connectors on the Light Head. (Pro Lights only)

2)Tighten the locking sleeves by rotating clockwise until tight.

Light Operation

Confirm that the mode selector (flat position of bezel around power button) is set to the P setting for Mini Pro Lights or E for Mini Elite Lights. (Refer Fig 24)

Operation from Smart Grips

1)Activate initial power-up by pressing the Pod Power Button. (Refer Fig 24)

After initial power-up lights may be controlled using LIGHT button on the left Smart Grip.

2)Turn off lights by pressing and holding the LIGHT button.

Operation from Battery Pods

1)Turn on light by pressing the Power Button on the rear cap.

2)Turn off light by pressing and holding the Power Button on the rear cap.

Power Button

(Fig. 24)

Replacing Handle Batteries

The battery life of your Smart Grip Handles will vary depending on usage and technique. But eventually the handle batteries will exhaust.

Replacing the handle batteries is an easy procedure. However, pay special attention to the wear of the O-ring and to the orientation of the batteries.

19

Image 19
Contents For the Sony HDR-HC3 camcorder Welcome Table of Contents Getting Started Camera Preparation Menu Setup Page Mounting the Camera Left Smart Grip Controls Refer fig OperationRear Plate Refer fig Smooth Slow Recording Lens Installation / Removal Using the Bluefin in VTR ModeBluefin Monitors Getting Started Reversing Smart Grip Button FunctionsAttaching the Remote or Compact Monitor Bluefin Monitor Bulkhead InstallationRemote Monitor Operation Compact Monitor OperationDiving Without a Monitor Attached Charging the Remote and Compact MonitorDisplay Icons on Monitors Bluefin Light Systems Getting Started Charging Batteries Installing BatteriesRemoving Batteries Replacing Handle Batteries Mounting Battery PodsConnecting Lights to Battery Pods Light OperationPre-Dive Checklist After Diving Care Housing StorageRing Care & Maintenance First Time UseLight & Motion European Service Center Other MaintenanceBluefin Accessories Light & Motion