Mamiya RZ67 PRO II, RZ67 Pro II Body Only manual Loading the Film Holder

Loading the Film Holder

Pull out the upper and lower Back Cover Latches and the back cover will open. Be- cause of the double safety lock, pulling out just one of the two Back Cover Latches will not open the cover. After opening the back cover of the Roll Film Holder, remove the Film Insert. When loading film, it is not nec- essary to remove the holder from the cam- era back. When loading film, avoid direct sunlight--either load in the shade or turn your body away from the sun and use the shade of your own body.

While holding down the left-hand Spool Release Pin of the Film Insert, fit a roll of film between the upper and lower left-hand Film Spool Studs. Make sure that the backing pa- per is set as shown in the photo above.

When loaded correctly, the inside of the backing paper (the black side) will appear on the outside of the insert back. If it does not, remove the film, turn it upside-down, and reload .

After feeding the tip of the backing paper into the slot of the Take-up Spool,

24