Speco Technologies HT-INTT5 manual Operating your camera Camera TITLE②, Next, Camera Title

8) NEXT PAGE

①Press the SET button to display the SETUP menu and move the arrow indicator to ‘NEXT PAGE’ using the UP or DOWN button.

② SET ‘NEXT PAGE’ to the desired mode using the LEFT or RIGHT button.

(1) CAMERA TITLE

①Press the SET button to display the SETUP menu and move the arrow indicator to ‘CAMERA TITLE’ using the UP or DOWN button.

② SET ‘ON’ using the LEFT or RIGHT button.

③Press SET button to access the SETUP mode.

④ You can enter up to 15 characters.

a. Move the cursor to character-enter location by using the LEFT

or RIGHT button.

b. Select the desired character by using the UP or DOWN button. c. Press SET button to confirm the blinking character. The first

character is saved and the cursor in the bottom of the screen moves to the next position.

d. Repeat above steps until you create the full name you want.

e. Select the position at which the CAMERA TITLE will be located on the screen.

-Move the cursor to ‘POS’ and press SET button.

-Select the position by using the 4-directional buttons, then press the SET button to confirm the position.

f. When completed, move the cursor to ‘END’ and press SET button.

Notes

●If the CAMERA TITLE feature is set to ‘OFF’, the name will not be displayed on the monitor.

23

Notes

●If you make a mistake while entering the name Move the cursor to ‘CLR’, press ‘SET’ button.

After erasing the character from right to left, correct the character again.

24