Speco Technologies HT-INTT5 manual Operating your camera Option, DIP Switch Setting on the Camera

Operating your camera ( Option )

1. When controlled by RS-485, Pelco-D protocol (Option), refer to the following.

A. DIP Switch Setting on the Camera

(Factory default : Camera Address = 01, Baud Rate = 2400bps)

①②

•Up to 15 Cameras can be controlled by 1 IR Remote Controller & 1 Receiver. You must set up each camera’s address by DIP Switches for proper addressing.

B. Receiver Setting to use with IR Remote Controller

(Factory default : Baud Rate = 2400bps, Chart is same as above)

Buzzer On/Off

Power Connector	485(+),(-)	Baud Rate Setting
(DC12V in)
	9

C. System Integration			•Please Observe Polarity!
	485(+)
	485(-)
		Receiver			IR Remote
	Multiflexer			Monitor	Controller

CCD Camera

D. IR Remote Controller ( Optional )

- Can call and control each camera on the monitor by the following.

UP button	SET button
LEFT button	RIGHT button

DOWN button

When you call Camera Address 01

->Push 0 Button

->Push 1 Button

->Push CAM Button

10