Q-SEE QUICK INSTALLATION GUIDE
MODEL NUMBER QR4274-418
PART 5 - SETTING UP CAMERAS FOR VIEWING AND RECORDING
From the Main menu, select CAMERA. Here you can setup the name display (up to 8 characters) and position of each channel (cameras). Select COLOR SETUP to adjust the image brightness, saturation, contrast and hue settings for each channel (camera). You can also choose whether each channel can be previewed in LIVE MODE and/or RECORDING MODE.
PART 6 - TO START RECORDING
This System offers 3 modes for recording:
1. Manual 2. Time Schedule 3. Motion Detection. From the main menu, select RECORD to enter into the Record Setup menu (shown at right).
CHANNEL: “ON” enables video to record from the respective camera. If the channel is set to “OFF”, video from that channel will not record.
RESOLUTION: D1=704x480, HD1=704x240, CIF=352x240
QUALITY: Best, Good, Normal
Using higher resolution and quality settings results in better video quality, but takes up more space on the hard drive. Choosing lower settings result in lower video quality, but takes up less space on the hard drive.
AUDIO: If audio is ENABLED sound will be recorded with the video from the channels, and will have audio output in playback mode. If audio is DISABLED, sound will not record, and there will be no audio output in playback mode (Audio cameras or a microphone is required to record the sound).
REC MODE: Sets DVR to record on Manual, Motion Detection & Time Schedule Recording (instructions below).
PACK TIME: Choose the time length of all recorded files: 15, 30, 45, 60 min. (Max = 60 min)
Grid Explanation:
Red = Alarm (motion detection) recording
Green = General (time schedule) recording
Transparent = No recording
Blue = The channel and date selected.
4 P a g e