Basic Functions
English |
IMPORTANT!
Before you operate the system, complete the preparation procedures.
Plug and Play (for tuner installation)
Plug and Play allows you to store all available RDS stations and radio stations automatically.
First time setup/power up
1When you turn on the main supply, "AUTO INSTALL - PRESS PLAY" is displayed.
2PressÉÅ on the system to start installation.
➜"INSTALL" is displayed, followed by "TUNER" and "AUTO".
➜PROG starts flashing.
➜The system will automatically store the radio stations with sufficient signal strength, starting from all RDS stations and followed by FM, MW and LW bands respectively. Weak RDS stations may be stored in later presets.
➜When all the available radio stations are stored or the memory for 40 presets are used, the last preset radio station (or the first available RDS station) will be played.
3The system will proceed to set the RDS clock if the first preset is an RDS station.
➜"INSTALL" is displayed, followed by "TIME" and "SEARCH RDS TIME".
➜When RDS time is read, "RDS TIME" is displayed and the current time will be stored.
➜If RDS station does not transmit RDS time within 90 seconds, the programme will exit automatically and the display will show “NO RDS TIME”.
●If the first preset is
➜The programme will exit automatically.
To reinstall Plug and Play
1In standby or demonstration mode, press and holdÉÅon the system until "AUTO INSTALL - PRESS PLAY" is displayed.
2PressÉÅagain to start installation.
➜ All previously stored radio stations will be replaced.
To exit without storing the Plug and Play
●Press Çon the system.
➜ If you do not complete the Plug and Play installation, the function will be restarted when you next turn on the main supply again.
Notes:
–When the power is turned on, the disc tray may open and close to initialise the system.
–If no stereo frequency is detected during Plug and Play, "CHECK ANTENNA" will be displayed.
–During Plug and Play, if no button is pressed within 15 seconds, the system will exit Plug and Play mode.
12
