Philips SPC620NC Click ‘ ’ to access the ‘Monitor settings’ menu, Deleting videologs

Page 23

OperatingChapter the WebCam

EN

Monitor settings

Click ‘’ to access the ‘Monitor settings’ menu.

>The following dialogue screen appears.

Enter the minimum memory capacity you wish to remain on your harddisk during recording.

>Recording stops automatically when harddisk space comes below the set amount of Mbs.

Check the ‘Notification’ box if you wish a notification to be send to an e-mail address when movement is detected.

Enter the e-mail address you wish the notification to be sent to.

Use the ‘Browse’ button to select an audio file if you wish an audio file to start playing as soon as movement is detected.

Use the sensitivity slider to set the desired sensitivity level for the WebCam detector.The sensitivity level determines the minimum amount of movement that will cause the WebCam to start recording.

The higher the sensitivity level, the sooner recording starts.

Click the ‘OK’ button to store your settings and close the dialogue box or click ‘’ or the ‘Cancel’ button to close the dialogue box without saving any settings.

Deleting videologs

1Select the logs you wish to delete in the content panel or under ‘By date’.

2Click ‘’.

> The following dialogue screen appears.

3Click the ‘OK’ button to delete the selected videologs.

23

Image 23
Contents SPC620NC Page WebCam Philips SPC620NCChapterLegend of functions Motion detection Broadcasting your videos over the Internet Safety precautions CopyrightChapterontents ENWelcomeChapter Do not use your WebCam in the water Safety precautionsThingsC apteryou should know CopyrightHave your Windows CD-ROM at hand ENInstallationChapterInstalling the WebCam software Installation continues automaticallyFollowing software license agreement appears InstallationChapterClick on Yes to continue the installation ’Reboot’ screen appearsAim the webcam as required Connecting the WebCam to your PC / laptopWebCam will now derive its power from the PC / laptop Flickerless image WebCamChapter settingsGeneral settings Frame rate ENWebCamChapter settingsVideo settings Full automatic control on/offUse the slider to set the desired shutter speed. Gain Auto ExposureShutter speed Brightness ChapterWebCam settingsBrightness enables you to adjust the brightness Audio settings Features settings There is sufficient light in the room ‘Features’ menu, check the ‘Change background’ boxChange background Actual background is staticLogo Used, when the option is enabled¡ Add logo Shown in the upper right corner of the screenSelect ‘Video Device’ OperatingChapter the WebCamVLounge Selecting your WebCamClick the ‘Capture’ tab to open the ‘Capture’ menu Capturing images / making video recordingsClick the ‘Communicate’ tab to open the ‘Communicate’ menu Deleting captured itemsFollowing dialogue screen appears Click the ‘OK’ button to delete the selected itemsClick ‘Start monitoring’ to start monitoring Motion detectionDetection and videolog recording Click the ‘Monitor’ tab to open the ‘Monitor’ menuClick the ‘OK’ button to delete the selected videologs Monitor settingsClick ‘ ’ to access the ‘Monitor settings’ menu Deleting videologsBroadcast your videos live Broadcasting your videos over the InternetTechnicalChapter specifications FCC compliance ChapterImportant informationDisclaimer System requirements Disclaimer of warrantyImportant information Environmental information