Radio Shack 15-1990 owner manual Preparation, Installing Batteries

Page 5

15-1990.fm Page 5 Tuesday, December 14, 1999 12:45 PM

PREPARATION

INSTALLING BATTERIES

Your remote control requires two AAA batteries (not supplied) for power. For the best performance and longest life, we recommend RadioShack alkaline batteries.

Cautions:

Use only fresh batteries of the required size and recommended type.

Do not mix old and new batteries or different types of batteries.

Do not press any of the remote control’s keys while installing batteries.

Note: The remote control’s built-in memory backup saves any programmed codes for about 10 minutes after the batteries have been removed. We recom- mend you have fresh batteries ready to install as soon as you remove the old ones.

1.Press the battery compartment cover’s tab and lift off the cover.

2.Place the batteries in the compartment as indi- cated by the polarity symbols (+ and ) marked inside.

3.Replace the cover.

When the remote control’s range decreases or it stops operating properly, replace the batteries.

Caution: Always remove old or weak batteries. Bat- teries can leak chemicals that can destroy electronic parts.

5

Image 5
Contents In-One Pocket Remote Control Convenient Keypad Design each key is posi FeaturesContents CBL, VCR, TV IntroductionPreparation Installing BatteriesDevice Types Setting UP Your Remote ControlVOL + To Operate Your TV/VCR Combination PUNCH-THROUGH OperationTurning Punch-Through Off/On ABC MANUFACTURERS’ CodesRCA NSCAOC TelevisionsCXC JCB JBLJVC KECNAD MTCNEC NTCSSS TMK CCE VCRsKLH HI-QMEI Fm Page 22 Tuesday, December 14, 1999 1245 PM STS Fm Page 24 Tuesday, December 14, 1999 1245 PM TV/VCR Combinations Fm Page 26 Tuesday, December 14, 1999 1245 PM Manual Code Search If YOU have ProblemsDetermining the 4-Digit Code Troubleshooting Care Specifications RadioShack Division of Tandy Corporation