Vol +

15-1990.fm Page 7 Tuesday, December 14, 1999 12:45 PM

3.Hold down P until the red light blinks twice, then enter the 4-digit code you wrote down in Step 1 using these keys:

	To Enter
Press	This Number

VOL +	1

VOL –	2

CH +	3

CH –	4

MUTE	5

For example, to replace a TV’s remote control (manufacturer’s code 1432), press TV, hold down P until the red light blinks twice, then press VOL +, CH – ,CH +, and VOL – .

When the red light blinks twice, the remote con- trol has accepted the code.

Note: If the code you entered is invalid, the red light blinks.

4.Point the remote control at your device and press POWER. Your device should turn off (or on, if it was off).

If the remote does not operate your device, try the other codes listed in “Manufacturers’ Codes” on Page 11 for your brand of TV, VCR, TV/VCR combination, or cable converter.

5.Repeat Steps 2–4 for additional devices.

MUTE