Radio Shack 15-1990 owner manual Device Types, Setting UP Your Remote Control

Page 6

15-1990.fm Page 6 Tuesday, December 14, 1999 12:45 PM

Warning: Dispose of old batteries promptly and properly. Do not burn or bury them.

Note: Do not place objects on top of the remote con- trol after you have installed the batteries. This can press keys for an extended period of time and reduce battery life.

DEVICE TYPES

You can use the remote control’s device keys to con- trol the following general types of devices:

TV — TVs

VCR — VCRs and TV/VCR combinations

CBL — Cable converters

SETTING UP YOUR REMOTE CONTROL

1.Refer to “Manufacturers’ Codes” on Page 11 and write down the codes for your brand of device on the 3-in-One’s label.

Note: Some manufacturers have several codes listed. Try each until you find the right one. See “If You Have Problems” on Page 27 if you cannot find the correct code.

2.Press the device key for the type of remote you are replacing (TV, VCR, or CBL). The red light blinks.

6

Image 6
Contents In-One Pocket Remote Control Features Convenient Keypad Design each key is posiContents Introduction CBL, VCR, TVInstalling Batteries PreparationSetting UP Your Remote Control Device TypesVOL + To Operate Your TV/VCR Combination Operation PUNCH-THROUGHTurning Punch-Through Off/On MANUFACTURERS’ Codes ABCNSC RCATelevisions AOCCXC JVC JBLJCB KECNEC MTCNAD NTCSSS TMK VCRs CCEHI-Q KLHMEI Fm Page 22 Tuesday, December 14, 1999 1245 PM STS Fm Page 24 Tuesday, December 14, 1999 1245 PM TV/VCR Combinations Fm Page 26 Tuesday, December 14, 1999 1245 PM If YOU have Problems Manual Code SearchDetermining the 4-Digit Code Troubleshooting Care Specifications RadioShack Division of Tandy Corporation