System Operation

2..Remove the Camera Handpiece from the handpiece holder and observe that the computer display shows the high-resolution live video images taken by the camera..

3..If desired, rotate the lens head left or right from center..

4..Place the camera lens window over area of interest and view image on computer display monitor.

5..Press and release the top keypad button on the Camera Handpiece to freeze (ie. capture) the displayed image on the computer monitor screen. The keypad button used may depend on the video capture software installed..

6..Press and release the bottom keypad button on the Camera Handpiece to save the captured image to the computer hard drive and then to return to a live image display. The keypad button used may depend on the video capture software installed..

7..Repeat steps 3 through 6 as necessary.

8..When imaging an X-ray film on a light box, deactivate the LED light source by depressing both Camera Handpiece buttons simultaneously for approximately 3 seconds. Perform steps 3 through 6 to freeze and save the X-ray film image as desired. Depress both Camera Handpiece but- tons simultaneously for approximately 3 seconds to turn ON the LED light source as desired..

9..Return the Camera Handpiece to the holder when done. Verify that the LED light source and camera turns OFF..

10..Set the STANDBY/ON switch on the Control Module front panel to the STANDBY position and verify that the front panel LED indicator lamp extinguishes..

Monitor-Connected System Operation - The Polaris System can be oper- ated directly connected to a video monitor. In this configuration the connected monitor displays high-resolution live video images taken by the camera.. There is no computer system or software used to freeze and save the resultant images. Perform the following procedures to operate the Polaris System when connected to a video monitor..

1..Activate the Polaris System by performing the Power Turn-On procedures provided on page 18..

2..Remove the Camera Handpiece from the Handpiece Holder and observe that the video monitor display shows the high-resolution live video images taken by the camera..

3..If desired, rotate the lens head left or right from center. Place the camera lens window over area of interest and view image on display..

4..When imaging an X-ray film on a light box, deactivate the LED light source by depressing both Camera Handpiece buttons simultaneously for approximately 3 seconds. Depress both Camera Handpiece buttons simultaneously for approximately 3 seconds to turn ON the LED light source as desired..

5..Return the Camera Handpiece to the holder when done. Verify that the LED light source and camera turns OFF..

6..Set the STANDBY/ON switch on the Control Module front panel to the STANDBY position and verify that the front panel LED indicator lamp extinguishes..