Mounting the Camera, cont.
Mounting the camera on a wall using the bracket provided
1.Knock out the ONE hole shown here on the base of the dome using a screwdriver and hammer.
2.Put a black rubber washer on the inside of base of the dome and then insert a brass screw into the
hole. Make sure that the end of the screw does not protrude from the wall of the base.
3. Attach a black rubber washer on the outside of the base.
4.Attach the camera to the base of the dome using the brass screw on the outside of the dome’s base.
Mounting the Camera, cont.
5.Plug the power and video cables into the camera.
6. Remove the lens cap (Don’t touch the lens).
7.Pass the cables through the hole in the mounting bracket and attach the
bracket to a wall.
8.Attach the base of the dome to the mounting bracket. Then, tightly fasten the dome assembly to the
bracket, by fixing the brass screw inside the dome.
9.Point the pip on the camera’s antenna in the direction of the TV that you connected the receiver to (if you’re using the wireless feature).
10.Attach the clear dome cover to the
base of the dome, using the 5 screws provided.
20 | 21 |