TRENDnet TVIP252P manual Configuring the IP Address of the PC

Page 27

3.3 Configuring the IP Address of the PC

If you have failed to access the camera, please check the IP address of your computer. When you connect the camera to your computer directly, proceed with configuration of the camera. You need to set up the IP addresses to be in the same segment for the two devices to communicate.

1.On your computer, click Start > Control Panel to open the Control Panel window.

2.Double-click Network Connection to open the Network Connection window.

3.Right-click Local Area Connection and then click Properties from the shortcut menu.

4.When the Local Area Connection Properties window appears, select the General tab.

5.Select Internet Protocol [TCP/IP] and then click Properties to bring up the Internet Protocol [TCP/IP] Properties window.

6.To configure a fixed IP address that is within the segment of the camera, select the Use the following IP address option. Then, enter an IP address into the empty field. The suggested IP address is 192.168.10.x (x is 1~254 except 30), and the suggested Subnet mask is 255.255.255.0.

7.When you are finished, click OK.

- 26 -

Image 27

Contents Page Preface Page Contents Specification Glossary of Terms Chapter Introduction to Your Amera Checking the Package Contents Connectors Getting to Know Your Camera Physical Components Connecting Cables  LED indicators  Link & Power switches Inside Components  Flexible Audio Capability Features and Benefits Remote Control Supported  MPEG4/MJPEG Dual-codec Supported Multiple Applications Supported  I/O Connectors Supported Multiple Platforms Supported  Multiple Profiles SupportedSystem Requirement Cameras within Your Network Applications of the Camera Basic Installation Surface Installing the CameraInstall the camera to the ceiling with three screws Page Page Using IPSetup Accessing the CameraPage Page Camera Display Area Click StartProgramsTRENDnetIPSetup, and then click IPSetupPage Accessing to the Camera  Live View/Setup Switch Page Click Tools Internet Options Click Security Configuring the IP Address of the PC Using the Web Configuration Chapter Configuring the CameraUsing Smart Wizard Camera SettingIP Setting Email Settings Confirm Settings  Basic System Basic Setup Basic Date & Time  Basic User  Direct Video Stream Authentication  General User Guest Network Settings  Network Network Page DNS  Ports Number  Network IP FilterPage Page  Video & Audio Camera Setting up Video & Audio Video & Audio Video  Image Setting MPEG4  Video & Audio Text Overlay  Video & Audio AudioPage  Event Server Setting FTP Event Server Configuration FTP  Email  Event Server Setting Email Event Server Setting Network Storage  Network Storage Motion Detect  Event Configuration General Setting Event Config Event Configuration Arrange Schedule Profile  Event Configuration Motion Detect Trigger  Event Configuration Schedule Trigger  Event Configuration Gpio Trigger Page Tools Page Information  Information Device Info Information System Log Logs table displays the events log recorded by the system Securview Software InstallationPage Page Page Page Using Installation  Controls Panel Item Features View Selection Panel  Camera Panel  Video View Window and Camera List Video Viewing  System PanelClick Add New Camera To add a cameraPage Page To remove a camera To link to the Web page of the camera  Manually record To Record Video Trigger recording by motion detection  Schedule Recording Configuration Select a camera Add Schedule Page To configure the recording settings Page To playback the recorded video To set up motion detection options Page Other AccountInformation Specification Codec  User Interface LAN Audio Input OutputGlossary of Terms Connector Pin AssignmentPage Numbers Bootp Enterprise HEX ISP Mjpeg 100 101 102 103 Limited Warranty 105 106 107 108