6.Do not allow any water droplets to get inside housing. This will cause the inside of the housing to fog.
7.Close housing lid tightly. Make sure there are no obstructions that prevent the housing from closing. Make sure lid is tightly pressed into housing.
8.Close housing latch. Make sure the lid is pressed evenly against the housing body look for obvious gaps which indicates something is trapped. The housing may leak if the lid is not evenly against the housing when closed. It is normal to see a small even gap between the housing lid and body.
Test camera and housing
1.Press the small power button on the top of the housing to turn camera power on.
2.Press the large shutter button on the outside of the housing to take a test picture.
3.The power or shutter button should have a smooth action and return to its original resting position after pressing. It is normal to feel some resistance when pressing the power and shutter button.
4.Press and hold power button to turn camera power off. It is recommended to leave camera power off until you’re ready to use camera to preserve battery power.
5.After 30 seconds the LCD and monitor will turn off, and the camera will in go into power save mode. To re- activate power, push any button.
6.After 3 minutes the camera power will shut down. To operate the camera, push the POWER BUTTON to turn on the camera.